mikrotik vlan routing configuration
Most Relevant Content
VLAN Routing Configuration between MikroTik RouterOS
VLAN (Virtual Local Area Network) is a logical topology that divides a single broadcast domain into multiple broadcast domains. It increases network security and performance as well as improves network efficiency. MikroTik VLAN routing configuration with manageable switch was discussed in previous article. Today we will learn how to configure VLAN between MikroTik RouterOS. This Router to router VLAN (layer3 VLAN) is useful when any ISP provide connection to one or more local ISPs who use MikroTik Router to maintain their LAN users. Network Diagram To configure VLAN between MikroTik RouterOS, I am following a network diagram like the below image. In this network, ether1 port of Core RouterOS is connected to internet having IP address 192.168.30.2/29. Ether2 port is connected to an Ethernet Hub. A hub is an OSI physical layer device. So, if there is a hub between Routers, then from Layer3 point of view it is the same as an Ethernet cable connection between them. Ether2 has two VLANs (VLAN 10 having IP address 172.22.2.1/30 and VLAN 20 having IP address 172.22.2.5/30). Ether1 port of Client RouterOS1 is connected to the Ethernet Hub. This port has a VLAN interface whose id is 10. So, it is able [...]
- »
MikroTik VLAN Routing Configuration with Manageable Switch | July 11, 2018
A VLAN (Virtual LAN) is a group of computers, servers, network printers and other network devices that behave as if they were connected to a single network. VLAN is a logical topology that divides a single broadcast domain into multiple broadcast domains. VLAN is a layer 2 method. So, a manageable switch is required to manage VLAN in your network and a router is required to route and control your inter-VLAN. VLAN increases network security and performance as well as [...]
- »
MikroTik VLAN and Bridge Configuration | September 19, 2017
VLAN and Bridge are two useful features in MikroTik Router. These two features are frequently used in any MikroTik network configuration. VLAN divides a physical interface into multiple logical interfaces. So, you can isolate your network into multiple logical networks on a physical interface. On other hand, MikroTik Bridge integrates multiple physical interfaces in a logical interface. So, you can extend your broadcast domain on multiple physical interfaces and can extend your popular services such as PPPoE or DHCP on [...]
- »
Hardening MikroTik RouterOS by Limiting Login Services | February 6, 2021
MikroTik RouterOS is usually used as a bridge between WAN and LAN network. WAN network is always an insecure network because attackers always try to hack your RouterOS so that they can compromise it for their own benefit. As a network administrator of MikroTik RouterOS, we should always take anti hacking steps to secure our MikroTik RouterOS. There are a lot of security tasks those we should take care to secure our MikroTik RouterOS. Among these security tasks, we will [...]
- »
Managing Disk Partition with the parted Tool in CentOS 7 | March 2, 2019
As a system administrator, sometimes you may require to manage partitions of your CentOS/Red Hat Linux Operating System. Partition management is always a risky task. But there are some useful tools those are so helpful to manage CentOS/Red Hat Linux disk partition easily. In my previous article, I discussed how to manage CentOS/Red Hat 7 HDD partitions with the fdisk utility. The fdisk tool is only eligible to manage MBR partition table. But GPT partition table is now becoming more [...]
- »
Troubleshooting Common Issues with Security Cameras in MikroTik Networks | February 7, 2025
30 Seconds Summary When fixing security cameras on MikroTik networks, you might see issues like bad video quality, connections dropping, motion detection not working, and security weaknesses. These problems can happen because of not enough internet speed, network congestion, IP conflicts, old software, or weak security. To fix these, make sure you have enough internet speed, set up the IP settings correctly, give camera traffic priority, and update the software regularly. Also, protect the cameras with strong passwords and encryption. [...]
- »
Single IP NAT Strategy in MikroTik RouterOS 7 | September 29, 2015
MikroTik Router has a lot of features which help to customize network as our requirement. Sometimes, it may be our requirement that we need to allow internet access on per IP. Normally, when we apply masquerade NAT rule in our MikroTik Router, all private IPs will be masqueraded or a network block will be masqueraded. If we do normal masqurade and enable a DHCP Server in our network, we may face a lot of unauthorized access in our network. Because [...]
- »
Boost Network Performance with MikroTik FastTrack in RouterOS 7 | October 27, 2025
Network administrators often face the challenge of balancing speed and stability. MikroTik’s FastTrack feature, introduced in earlier RouterOS versions and optimized in RouterOS 7, is a game-changing solution that dramatically enhances performance by reducing CPU load and improving packet handling efficiency. 🚀 What Is MikroTik FastTrack? FastTrack is a special processing method in RouterOS that allows packets from established and related connections to bypass the standard connection tracking process. In simple terms, once a connection is identified as safe and [...]
- »
MikroTik UserMan RADIUS Server Customers, Users and Routers | November 13, 2017
MikroTik User Manager RADIUS Server is a centralized user authentication and accounting application that gives the ISP Company or network administrator ability to manage MikroTik RouterOS user, PPP user and Hotspot user so smoothly. There are two methods to install MikroTik User Manager RADIUS Server in your network. You can install User Manager Package either on a physical RouterOS or on a dedicated Server Machine or on a Personal Computer where RouterOS is running. How to install and configure User [...]
- »
How to Create Free SSL/TLS Certificate with OpenSSL | July 23, 2021
SSL/TLS certificate is required to encrypt data sent over internet communication. Without encryption, the sent data can be hacked by the middle man attack. SSL/TLS certificate is usually a pair key, public key and private key, solution where data is encrypted with public key and decrypted with private key. In public communication, public key is required to be signed by a CA (certificate authority) but in private communication, there is no need to be signed by any CA. If we [...]
More Similar Content
You May Also Like
